ELM 327 OBDII Car Diagnostic Tool OBD2 Code Reader Scanner For IOS Android
1. Fully compatible with ELM327 V1.4b. 2. All ELM327 supported software are available to use. 3. Faster than ELM327 four times or higher. (ELM327 is RISC 8bit 44MHz MCU, iCar is ARM 16bit MCU) 4. Due to the android diagnostic software becomes heavier to run, suggest to use on smart phone with CPU 800Mhz or higher, 1GHz recommended. 5. Built in power switch. 6. Low standby power consumption sleep mode. 7. Lower power consumption than ELM327 8. LED indicator is in the front side toward user for easier check of linking status. 9. Support J1939 protocol more than ELM327. 10. WiFi 802.11 b/g or 802.11n module.
1. OBDII decode chip: ARM 16bit MCU 2. Firmware: ELM327 Version 1.4b compatible 3. Transfer baud rate: 4800 / 9600 / 10400 / 38400 (default) / 115200 / 500K 4. Input interface: OBDII male 16pin 5. Output interface: Wifi 802.11 b/g or 802.11n after 2013 Feb 01 6. LED Indicator: Power(red) / OBD(green) / Link(blue) (PC or smart phone) 7. Operating Voltage: 12V from car OBD2 socket, including over voltage /shortage protection 8. Nominal Idle current: 45mA 9.Communication range: 500m open field 10.SSID: VGATE (discontinued) or BUYOBD (current) 11.Encryption: Open (VGATE) and WEP shared/WEP128 (BUYOBD)